Cleaning And Maintenance Of Laser Protective Lenses
Leave a message
The material of the focusing lens is brittle and fragile, with an anti reflective film on the surface, which is afraid of pollution, moisture, oil, and scratches. Dry and degreased air should be provided during work, and recommended cleaning equipment and methods should be used for cleaning.
The equipment should ensure sufficient air pressure during operation. Before operation, the gas blowing and pressure can be checked by reaching out to the light outlet of the focusing lens with your fingers.
Before starting up for the first time every day, remove the lens barrel containing the focusing lens and observe if it is contaminated. The principle of cleaning focusing lenses is to avoid cleaning as much as possible without contamination, and to clean them promptly if there is contamination.
Cleaning steps
Loosen the fastening screws, remove the air nozzle and lens barrel in sequence, and first use a blowing balloon to blow away the dust on the surface of the lens.
If you need to clean the lens, use a laboratory grade paper cotton ball dipped in an appropriate amount of acetone or high-purity alcohol, and rotate it clockwise from the center of the lens towards the edge. If necessary, clean both sides carefully and meticulously.
Install the lens barrel and air nozzle, adjust the focal length, and tighten the fastening screws

